80 Series Double Cup Holder

This is a 3D printed double cup holder for a 1991-1997 Toyota Landcruiser & 96-97 Lexus Lx450. It comes with the standard black insert which is the universal 3 cup holder diameter. The insert removed gives you a 3.85 hole to accept the large nalgene & hydroflask bottle. You will also receive a single insert sleeve that goes inside either of the black inserts to allow a snug fit while offroad for those narrow beverage containers like travel mugs, grocery store water bottles, soda cans, kids fast food cups, ect. This can also hold a cell phone, 2 pens, & a flashligh while holding 2 cups at the same time. This is made in ABS plastic. It comes in the factory tan, gray, or flat black (for the folks with the dark brown that came in the 91-94 Landcruiser). We also offer these in the Right Hand Drive (RHD) version for the international crowd BUT this will NOT work for the manual transmission console. ONLY fits on the automatic console. To install; clean the console well to remove any dirt/grease. Remove the backing on the 3m adhesive & install the two silver side screws first. Screw in until snug & stop. Then install the two black screws under the black inserts. Screw in until snug & stop. Don't overtighten & strip. You are screwing into plastic. 80 Series Double Cup Holder