Enhance your interior with this slim handcrafted plaster air vent cover, proudly made in the UK. Model S13 features a narrow, elegant geometric lattice design, making it ideal for installation in skirting boards, as well as on walls & ceilings. Thanks to its compact 102 mm width, this vent cover is perfectly suited for skirting board ventilation, offering a discreet, built-in appearance while maintaining effective airflow. Each piece is individually handmade using Crystacal R plaster reinforced with fibreglass, providing excellent strength & long-term stability. Supplied in a raw plaster white finish, it can be painted in any colour to match your interior perfectly. The vent is surface-mounted using adhesive fixing (no screws required), ensuring a clean, professional finish. A pre-installed anti-insect mesh protects your interior from spiders & insects while maintaining full ventilation efficiency. Key Features Handmade in the UK Reinforced with fibreglass Suitable for skirting boards, walls & ceilings Fully paintable Integrated anti-insect protection mesh Slim decorative lattice design Quick DIY installation with adhesive Large warehouse stock availability Fast order fulfilment Shipping via RoyalMail24 Tracked ???? Technical Data Model: S13 Overall Size: 297 102 mm (11.69 4.01 inch) Material: Crystacal R plaster reinforced with fibreglass Finish: Raw plaster - ready for painting Installation: Surface-mounted with adhesive (included) Application: Skirting boards / Walls / Ceilings Tolerance: 2-3 mm (due to handmade production) Installation & Safety Information Supplied adhesive is safe for skin, but protective gloves & safety glasses are recommended in case of skin contact, wash with warm water & soap Always secure the area below the vent during drying Check adhesion strength before full use Keep out of reach of children ???? Important: During adhesive curing, the vent cover must be mechanically supported (e.g. tape, brace, prop). Failure to support during curing may cause detachment within minutes, especially on uneven, dusty or freshly painted surfaces. Damage caused by lack of mechanical support during curing is not covered by warranty. The adhesive supplied is a suggestion only. If required, use an adhesive suited to your specific wall or ceiling surface. Full adhesive information is supplied with your order. ???? Painting Advice You may paint the cover immediately after unpacking using standard emulsion paints. For best results: Apply 3 thin coats First coat may be slightly diluted with water Allow full drying between layers The mesh can remain installed when using a roller or sponge. For spray or brush painting, the mesh can be temporarily removed & reattached later. ???? Shipping Information Free UK delivery via RoyalMail24 Tracked. Fast dispatch from warehouse stock. Plaster Skirting Board Air Vent Cover S13 - 297 102 Mm Made in UK