SLOPED FLOOR SHOWER PROFILE FOR GLASS LEFTDesigned for glass from 8mm up to 10mm thick For 8 mm glass it is necessary to use the gasket2% reductionlengths: 1200 cmstainless steel SUS 304 - PVDSloped strips for a linear drain are the best solution if you value a professional approach to finishing your bathroom. Thanks to the shower tray strip, your shower will acquire a neat and elegant look.The sloping glass strip differs from the classic variant with a special position for the shower glass, which is intended to mask the unsightly silicone finish and facilitate installation.The strip forces a 2% drop, so you can be sure that your shower is perfect in every respect, both technically and visually.How to choose the right strip?Remember that the strips are available in right and left variants and in two standard lengths: 120 cm / h 3 cm and 180 cm / h 4 cm.Stand in front of the drain of the line: your left hand is the left strip and your right hand is the right strip. If you have a wall on one side, remember that instead of a perimeter strip, you should use a wall strip or not use a strip at all.Important note:If you use the 180 cm side profile (LPSP 180 cm) and at the same time want to use the front profile (LC) on the front part of the shower tray, due to the compatibility of the elements, this profile must also be purchased in the 180 cm version (LC 180 cm), just as the 120 cm side profile (LPSP 120 cm) must be used with the front profile (LC) of the 130 cm shower tray (LC 130 cm).